H3C S7500E Series Command Reference

9-10
display link-aggregation summary
Syntax
display link-aggregation summary [ | { begin | exclude | include } regular-expression ]
View
Any view
Default Level
1: Monitor level
Parameters
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see CLI Configuration in the Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays the lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, which is a case sensitive string of 1 to 256
characters.
Description
Use the display link-aggregation summary command to display the summary information of all
aggregation groups.
You may find that information about the remote system for a static link aggregation group is either
displayed as none or not displayed at all. This is normal because this type of aggregation group is not
aware of its partner.
Examples
# Display the summary information of all aggregation groups.
<Sysname> display link-aggregation summary
Aggregation Interface Type:
BAGG -- Bridge-Aggregation, RAGG -- Route-Aggregation
Aggregation Mode: S -- Static, D -- Dynamic
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Actor System ID: 0x8000, 000f-e267-6c6a
AGG AGG Partner ID Select Unselect Share
Interface Mode Ports Ports Type
-------------------------------------------------------------------------
BAGG1 S none 1 0 Shar
BAGG10 D 0x8000, 000f-e267-57ad 2 0 Shar
Table 9-5 display link-aggregation summary command output description
Field Description
Aggregation Interface Type
Aggregate interface type:
 BAGG for Layer 2 aggregate interface
 RAGG for Layer 3 aggregate interface

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English