H3C S7500E Series

20-16
If no port is specified, this command displays the types of advertisable optional TLVs of each port.
Examples
# Display the types of advertisable optional LLDP TLVs of interface GigabitEthernet2/0/1.
<Sysname> display lldp tlv-config interface gigabitethernet 2/0/1
LLDP tlv-config of port 1[GigabitEthernet2/0/1]:
NAME STATUS DEFAULT
Basic optional TLV:
Port Description TLV YES YES
System Name TLV YES YES
System Description TLV YES YES
System Capabilities TLV YES YES
Management Address TLV YES YES
IEEE 802.1 extend TLV:
Port VLAN ID TLV YES YES
Port And Protocol VLAN ID TLV YES YES
VLAN Name TLV YES YES
IEEE 802.3 extend TLV:
MAC-Physic TLV YES YES
Power via MDI TLV YES YES
Link Aggregation TLV YES YES
Maximum Frame Size TLV YES YES
LLDP-MED extend TLV:
Capabilities TLV YES YES
Network Policy TLV YES YES
Location Identification TLV NO NO
Extended Power via MDI TLV YES YES
Inventory TLV YES YES
Table 20-5 display lldp tlv-config command output description
Field Description
LLDP tlv-config of port 1 Advertisable optional TLVs of port 1
NAME TLV type
STATUS
Indicates whether TLVs of a specific type are currently sent through a
port
DEFAULT
Indicates whether TLVs of a specific type are sent through a port by
default