IconMaster Installation and Configuration Manual 133
Chapter 6: Machine Control
Edge Protocol Gateway
The Edge protocol gateway provides external connectivity to any Leitch/Harris
routing system. It translates between Leitch/Harris and other manufacturers’
routing control systems. On an IconMaster system, the Edge would be
connected to either a Panacea or a Platinum router to access third-party
protocols and commands.
Before you can make any connections to an IconMaster, the Edge must already
be configured as desired. If your Edge is already operational, you do not need to
configure it. If, however, your Edge is not already operational, you must install
and configure it as desired for your facility. See the Edge Protocol Gateway
Installation and Frame Configuration Manual for detailed information.
You can use an Edge to allow the IconMaster to “talk” to certain third party
routing systems. See the Protocol Translation Functions Firmware Installation,
Configuration, And Operation Manual for a list of supported third-party
protocols and commands.
To Next Page
Loading...