IconMaster Installation and Configuration Manual 201
Chapter 8: Configuring IconMaster
Network Settings
Figure 8-34. Network Dialog Box
The Network dialog box contains the network address settings that are
necessary for the ICU program to communicate with the IconMaster’s
MKE-3901 module, and for the MKE-3901 to communicate with IconMaster’s
RCP control panels. It also contains selections for external interface devices
(such as the JLCooper Electronics eBox® Quad Serial to Ethernet Interface
1
)
and their corresponding network address settings.
You can rename each frame that contains IconMaster components by clicking in
the Iconmaster Channel Name field, and then typing the new name. A
maximum of 8 characters is allowed for a host name.
The default network IP address of the IconMaster’s MKE-3901 module is
192.168.100.252.
• If this address has not been changed on the MKE-3901 module, then this
setting should not be changed.
• If you have changed the IP address of the MKE-3901 using the module’s
card-edge display, enter the new IP address in the IP Address field.
1
eBOX is a trademark of JLCooper Electronics.
To Next Page
Loading...