152 IconMaster Installation and Configuration Manual
Chapter 8: Configuring IconMaster
Frame Configuration Menu Groups
When you choose to create a new IconMaster Frame Configuration (File > New
> IconMaster Frame Configuration), four menu groups will appear. They are
described in the following sections:
• “Input/Output Group Settings” on page 156
• “Functional Group Settings” on page 169
• “Control Group Settings” on page 183
• “System Config Group Settings” on page 191
Panel Menu Group
When you choose to make a new Control Panel Configuration (File > New >
Control Panel Configuration), one menu group will appear. For information on
this menu group, see “Panels Group Settings” on page 208.
Initializing IconMaster
Once you have started the IconMaster configuration utility, you will need to
make adjustments to the following settings:
• Network settings
• Operating standard
• System timing
Network Settings
The default IP address will function correctly in a “one frame and one panel”
configuration if both frame and panel are connected to the same switch that is
not connected to a network server or router. However, if you are connected to a
network server or router, you will need to coordinate the IP address for the
MKE-3901 module, the MGI-390x module, and/or the IconMaster control
panel.
Notice that there are two different network settings selections within the main
menu groups. One selection controls network settings for the frame (found in
the System Configuration menu group), and the other selection controls the
network settings for the control panel (found in the Panel Configuration menu
group).
If you have changed the IP address on the card edge of the MKE-3901 module,
you must make the same change in the Network dialog box (see page 201 for
more information on changing this setting).
To change the network settings of the IconMaster control panel, access the
Panel Network Configuration dialog box (see page 209 for more information
on changing this setting).
To Next Page
Loading...