68 IconMaster Installation and Configuration Manual
Chapter 3: Module Configuration
Navigating the MKE-3901 Operator and All Lists
To navigate, and then view or change a parameter from the Operator and All
Lists, follow these steps:
1. Open the front panel of the NEO frame.
2. Press any card-edge control to turn on the VFD screen.
The message MKE3901 appears. If a previous user has left the display at a
different parameter name, repeatedly press the Escape button until the
message MKE3901 appears.
After several seconds of inactivity, a scrolling message will appear,
describing the purpose of the currently selected parameter.
3. Push the Enter button.
The name of the first parameter option in the list appears.
4. Push the Enter button again to access the options for the parameter
displayed on the VFD screen.
OR
Press the Nav+/Nav- switch down repeatedly to view other parameters, and
then press Enter to access an item’s parameter options.
5. Press the Nav+/Nav- switch up or down to scroll through the different
selectable parameter options, and then press Enter to select the value you
want.
OR
Press the Nav+/Nav- switch up or down to adjust the numeric parameter
value, and then press Enter.
6. Close the front panel of the frame to ensure the cooling system continues to
operate properly.
To Next Page
Loading...