Harris IconMaster - Installing the Optional MKA-3901 Submodule; Installing the Optional MKE-3901-FX Submodule; Installing the NEO Frame into a Rack

IconMaster Installation and Configuration Manual 37
Chapter 2: Installation
Installing the Optional MKA-3901 Submodule
The MKA-3901 submodule can be ordered separately. (If you ordered this
optional module at the same time as your IconMaster, it will be installed in the
NEO frame at the manufacturing facility, and no further NEO module
installation procedures are necessary.) If you have ordered the module
separately and need to install it in your IconMaster system, follow these steps:
1. Remove the MKE-3901 module from the NEO frame.
2. Fit the MKA-3901 module to the MKE-3901 module.
3. Secure using standoffs and retaining screws.
4. Reinstall the MKE-3901/MKA-3901 into the NEO frame, and then close
the front panel.
Installing the Optional MKE-3901-FX Submodule
The MKE-3901-FX submodule can be ordered separately and added to an
existing MKE-3901 module. (If you ordered this optional module at the same
time as your IconMaster, it will be installed in the NEO frame at the
manufacturing facility, and no further NEO module installation procedures are
necessary.) If you have ordered the module separately and need to install it in
your IconMaster system, follow these steps:
1. Remove the MKE-3901 module from the NEO frame.
2. If your system includes an MKA-3901 module, remove the four retaining
screws from the MKA-3901 module, and then separate the MKA-3901
module from the MKE-3901.
Retain the screws.
3. Locate and fit the MKE-3901-FX module into the correct position on the
MKE-3901 module.
4. Install the submodule with the retaining screws included.
5. If applicable, fit the MKA-3901 module to the MKE-3901 module again.
6. Secure using standoffs and retaining screws.
7. Reinstall the MKE-3901 into the NEO frame, and then close the front panel.
Installing the NEO Frame into a Rack
For instructions about installing a NEO frame into a rack, see the FR-3901,
FR-3903, and FR-3923 Mounting Frames Installation and Operation Manual.
Your installation may also require breakout panel connections. See page 43 for
more information.