IconMaster Installation and Configuration Manual 143
Chapter 7: Automation Setup
Procedure
To set up a key mask in IconMaster, perform the following steps from a
MS-Windows computer connected to the same network as your IconMaster
system:
1. Open a command prompt window by selecting the <Start> button at the
bottom left of the screen. Select the RUN menu item, and then type
cmd in
the field.
2. Press OK. A command prompt window will appear.
3. Begin a telnet session by typing
telnet xxx.xxx.xxx.xxx
(
xxx.xxx.xxx.xxx = the IP address of the IconMaster's MKE-3901
module).
4. Type
leitch as the username.
5. Type
LeitchAdmin as the password.
6. To display the current automation key mask, type
getAutoKeyMask, and
then press <Enter>. The hex encoded key mask will be displayed, along
with the IconMaster's interpretation of the code.
For example:
-> getAutoKeyMask
Ignore the “value =” return line.
7. To set the current automation key mask, type setAutoKeyMask 0xHH
and then press <Enter>. (
HH is the hex-encoded key mask [i.e., 0x30].
Include the
0x [zero and x] characters when entering the hex number.
Again, ignore the “value =” return line.)
8. To verify the current automation key mask, type
getAutoKeyMask, and
then press <Enter>.
Auto Key Mask: 0x30
Displays the current hex encoded key mask
Bit 0 - Key1: 0
Displays the status of keyer 1:
0 = keyer under automation
Bit 1 - Key2: 0
Displays the status of keyer 2:
0 = keyer under automation
Bit 2 - Key3: 0
Displays the status of keyer 3:
0 = keyer under automation
Bit 3 - Key4: 0
Displays the status of keyer 4:
0 = keyer under automation
Bit 4 - Key5: 1
Displays the status of keyer 5:
1 = keyer automation ignored
Bit 5 - Key6: 1
Displays the status of keyer 6:
1 = keyer automation ignored
To Next Page
Loading...