IconMaster Installation and Configuration Manual 195
Chapter 8: Configuring IconMaster
• Router Database
If the IconMaster is configured with static inputs (router sources are
assigned to IconMaster inputs, without the operator ability to change the
router assignments), then do not use the Router Database settings. However,
if you wish to use the dynamic routing features of IconMaster, or to use an
existing router database to select your IconMaster sources (regardless of
Dynamic Routing use), select the Using Routing Database checkbox.
• Selecting Sorted will optionally sort the router database
alphanumerically.
• If Using Routing Database is selected, you will need to create a router
database using the RouterMapper software application, and then send
this database to the IconMaster through the Navigator application.
You cannot use the native RouterMapper DA4 database; you must
convert it into an XML format through CCS Navigator™. See
page 218
for detailed instructions.
• Set the value in the Router Transition Delay spin box as appropriate for
your router.
• The router transition delay can be a value between 1 and 15. For Platinum
routers, typically a value of “5” is required. With most other routers, the
default setting of “1” will suffice. Assessment of the performance of your
channel release system should be performed to ensure that the router
transition delay meets your station’s requirements.
To Next Page
Loading...