Procedure
Step 1 Create VLANs and add interfaces to the VLANs.
Step 2 Configure the IP address of each VLANIF and the unicast routing protocol according to Figure
2-2.
Step 3 Enable IGMP and SSM mapping on the interfaces connected to hosts.
[S9300-D] multicast routing-enable
[S9300-D] interface vlanif 10
[S9300-D-Vlanif10] igmp enable
[S9300-D-Vlanif10] igmp version 3
[S9300-D-Vlanif10] igmp ssm-mapping enable
[S9300-D-Vlanif10] quit
Step 4 Configure the range of SSM group addresses.
# Set the range of SSM group addresses to 232.1.1.0/24 on all S9300s. The configurations of
S9300-B, S9300-C, and S9300-D are similar to configuration of S9300-A, and are not mentioned
here.
[S9300-A] acl number 2000
[S9300-A-acl-basic-2000] rule permit source 232.1.1.0 0.0.0.255
[S9300-A-acl-basic-2000] quit
[S9300-A] pim
[S9300-A-pim] ssm-policy 2000
Step 5 Configure static SSM mapping rules on the S9300s connected to hosts.
# Map the multicast group in the range of 232.1.1.0/24 to Source 1 and Source 3.
[S9300-D] igmp
[S9300-D-igmp] ssm-mapping 232.1.1.0 24 133.133.1.1
[S9300-D-igmp] ssm-mapping 232.1.1.0 24 133.133.3.1
# Check the information about SSM mapping of specific sources and group addresses on S9300s.
<S9300-D> display igmp ssm-mapping group
IGMP SSM-Mapping conversion table of VPN-Instance: public net
Total 2 entries
Total 2 entries matched
00001. (133.133.1.1, 232.1.1.0)
00002. (133.133.3.1, 232.1.1.0)
Step 6 Verify the configuration.
# The Receiver joins the group 232.1.1.1.
# Run the display igmp group ssm-mapping command to view the information about the
specific sources or group addresses on the S9300s. Take the information about the specific source
or group address on S9300-D for example:
<S9300-D> display igmp group ssm-mapping
IGMP SSM mapping interface group report information of VPN-Instance: public net
Vlanif10 (133.133.4.2):
Total 1 IGMP SSM-Mapping Group reported
Group Address Last Reporter Uptime Expires
232.1.1.1 133.133.4.1 00:01:44 00:00:26
<S9300-D> display igmp group ssm-mapping verbose
Interface group report information of VPN-Instance: public net
Vlanif10 (133.133.4.2):
Total entry on this interface: 1
Total 1 IGMP SSM-Mapping Group reported
Group: 232.1.1.1
Uptime: 00:01:52
2 IGMP Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
2-26 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 01 (2009-07-28)
To Next Page
Loading...
