iZ Technology Corporation
Q3 represents the slowest speed but highest quality.
The order of the tracks will be determined by one of the following:
• The sequence that the CDAUDIO files were exported directly to the CD.
• The sequence that the CDAUDIO files were exported into the destination folder/directory.
• The list created at the SELECT FILES: submenu of BURN AUDIO CD.
See the OPERATIONS: FILE MANAGEMENT: EXPORT section of this manual for specific details.
The length of time between audio tracks is fixed at two seconds.
To create an audio CD:
Insert a blank CD-R into the multi-drive.
Use one of the following methods:
a. Export directly to B:CD-R BLANK. Do NOT proceed to step 3. Instead, refer to the
OPERATIONS: FILE MANAGEMENT: EXPORT section of this manual for specific details.
b. Use the , the and keys and the key to go to the MAIN MENU /
FILE MENU / BURN AUDIO CD dialogue and press the key. Proceed to step 3.
Either method allows the CD to be finalized immediately after the burn is complete or at a
later time. If NO is selected at the FINALIZE CD prompt, RADAR will display the CD as
B:CD-R OPEN.
At the BURN FROM: dialogue, use the and keys to select the drive that contains the
folder/directory of STEREO CDAUDIO files and press the key.
At the SELECT FOLDER: dialogue, use the and keys and the and keys to locate
the folder or <ROOT DIRECTORY> to burn from and then press the key.
At the BURN FILES: dialogue, use the and keys to select ALL FILES or SELECTED
FILES and press the key. This step will determine the order of the tracks on the CD. If ALL
FILES is selected, the CD track order will reflect the sequence that the files were exported. If
SELECTED FILES is chosen, the track order will be based upon the selected list created under
the SELECT FILES: dialogue.
If ALL FILES is selected, proceed to step 7.
To Next Page
Loading...
