www.izcorp.com • 1.800.776.1356
RECORD 24 TRACKS AT 192 KHZ (ADRENALINE PLUS CARD ONLY)
With this mode enabled, 24 tracks can be recorded at 192 kHz, however crossfades will not be processed
until the transport is stopped. During this time the LCD will display the +WORKING+ message.
RADAR is able to process 12 tracks seamlessly (in real time) at 192 kHz. If real-time crossfades are
required, disable the 24 track mode and select the 12 tracks to record.
To enable/disable 24 TRKS AT 192K:
Use the , the and keys and the key to go to the MAIN MENU / DISK
MENU / 24 TRKS AT 192K DIALOG and press the key.
Choose ENABLE/DISABLE and press the key.
If DISABLE is selected the RADAR will prompt to SELECT TRACKS. Choose from:1-12 13-24
SELECTED (using the Track Arm keys, select the desired tracks)
After making a selection, press the key.
SEAMLESS 64K
This function allows users to have 24 tracks of seamless recording during punch ins/outs when using a
64k cluster initialized drive. This mode will prevent any time delay between recordings.
With SEAMLESS 64K enabled, recording and punching in/out without editing requires a
minimum 7200 RPM drive whereas a heavily edited project requires a minimum 10,000
RPM drive.
To enable or disable seamless 64k mode:
Use the , the and keys and the key to go to the MAIN MENU / DISK
MENU / SEAMLESS 64K dialogue and press the key.
At the SEAMLESS 64K: dialogue, use the and keys to choose ENABLE or DISABLE and
then press the key.
CLONE RADAR DISK
This function provides an easy way to copy data from one hard drive to another.
To clone a disk:
Unmount the drive by pressing + (UNMNT) key on the Session Controller or use the
, the and keys and the key to go to the MAIN MENU / DISK MENU /
MOUNT/UNMOUNT dialogue and press the key.
Use the , the and keys and the key to go to the MAIN MENU / DISK
MENU / CLONE RADAR DISK dialogue and press the key.
To Next Page
Loading...