www.izcorp.com • 1.800.776.1356
RECORD RECOVERY MODE
Record Recovery mode is designed for live recording only and therefore is disabled by default on
RADAR. While recording, RADAR writes all the data to the recording drive constantly, but a save state is
required once the transport is in stop to update the file lengths and header information. If power is lost
during recording, and a save state is not performed, it can be a lengthy procedure to retrieve and rebuild
the project. If RADAR’s RECORD RECOVERY MODE is enabled, RADAR will constantly update the file
lengths and header information. Writing this data to the system drive allows a quick procedure to rebuild
the project.
To enable record recovery:
Go to MAIN MENU / PREFERENCES MENU / RECORD PREFS / RECORD RECOVERY and
press the key.
At the RECORD RECOVERY prompt use
the
and keys to select ENABLED and press the
key.
At the SHUTDOWN TO ENABLE CHANGES press the key.
At the system shutdown proceed? prompt use
the
and keys to select YES and press the
key. RADAR will unmount all drives and display YOU MAY SAFELY TURN OFF POWER.
Reboot from the power switch on RADAR to enable changes.
When RECORD RECOVERY is enabled each time RADAR mounts a drive the message
RECORD RECOVERY ENABLED will be displayed. Press the key to continue
mounting drives.
If power is lost during recording, upon a reboot:
At the UNSAVED DATA RECOVER IGNORE prompt use the
and keys to select
RECOVER and press the key.
At the SAVE TO prompt select the volume to save the Record Recovery Information Files to
(please note, this is not the audio being saved).
After the files are saved on the selected volume, the user will be prompted to: CONTACT
SUPPORT FOR INSTRUCTIONS
Do not mount the disk again. The audio drive along with the media that contains the Record
Recovery Information Files will need to be sent to iZ Technology for recovery. Call iZ Support for
instructions.
To Next Page
Loading...
