iZ Technology Corporation
PLAYBACK
_____________________________________________
CHASING TIMECODE AND CLOCK SYNCHRONIZING
For audio recorded on RADAR to match up with video, a time location reference (timecode) is required.
Since RADAR will be chasing an external timecode source, RADAR should be clocked to the same clock
reference (Sync) as the timecode generator. Since RADAR will be in external CHASE and external
SYNC, for stable live recording the following settings are recommended:
Use the , the and keys and the key to go to the MAIN MENU / SYNC
MENU / TC SETTINGS / CHASE MODE dialogue and press the key.
At the CHASE MODE prompt use the and keys to select LOCK-AND-DROP and press the
key.
Under this setting, RADAR will lock to timecode and then ignore it. RADAR will stay in sync, since the
internal clock will be synced to the same video clock source as the timecode generator. This prevents
RADAR from dropping out of record because of timecode issues.
THEATER MODE PREFERENCES AND LOCATE POINTS
There are a number of preferences in RADAR to assist with live playback.
ARROW KEY GOTO
Use the , the and keys and the key to go to the MAIN MENU /
PREFERENCES / ARROW KEY GOTO dialogue and press the key.
At the ARROW KEY GOTO: prompt use the and keys to select IN/OUT or LOC LIST
and press the key.
When LOC LIST is selected, the key will locate RADAR to the previous locate in the list and the
key will go to the next locate in the list not including MARK IN/OUT markers. If PREROLL is enabled, it
will add and preset offset to the locate. If AUTOPLAY is enabled, then RADAR will enter PLAY mode
after locating.
STOP AT LOCATE
The STOP AT LOCATE option can be enabled on a per project basis. When ENABLED RADAR will
automatically stop playing when it reaches a locate point.
To ENABLE or DISABLE STOP AT LOCATE on the current opened project:
Navigate to MAIN MENU / PROJECT MENU / STOP AT LOCATE and press the enter key.
Use the and keys to select DISABLED or ENABLED at the STOP AT LOCATE and press
the key.
To Next Page
Loading...