iZ Technology Corporation
Type information to be stored in the general notes, and then use the
key to go to the next line.
Press the key to exit PROJECT NOTES.
To enter track notes, press a Track Arm key through while in edit mode. At the NOTES
FOR TRK:XX prompt, enter details about that specific track. Press to return to the
general notes, or to exit PROJECT NOTES.
To save the PROJECT NOTES:
Use the , the and keys and the key to go to the MAIN MENU / PROJECT
MENU / PROJECT NOTES dialogue and press the key or press the
key on the
Session Controller.
At the PROJECT NOTES: prompt select SAVE AS and press the key.
At the SAVE TO: prompt, use the and keys to select the device to save to, and press the
key. This list will include D:ARCHIVE (RADAR internal system drive partition),
N:NETWORK, A:FLOPPY, B: (DVD-RAM, DVD-R, BD-RE or CD-R), REV DISK, E:USB DRIVE
and any FAT32 or HFS Standard formatted SCSI drives connected to the RADAR.
At the SELECT FOLDER: prompt, select the destination folder using the and keys and
press the key.
Project notes are also saved automatically on the audio drive. A project notes text file is
automatically included whenever a File Flatten, backup or a mono export is executed.
After you have finished using a USB drive, make sure you unmount it before unplugging it
from RADAR. You can access the MOUNT/UNMOUNT dialog via the DISK MENU or by
pressing + UNMNT on the Session Controller.
GOTO PROJECT
To go to a new project:
Press the key on the Session Controller, the key on the KC-24 or use the
, the and keys and the key to go to the MAIN MENU / PROJECT MENU
/ GOTO PROJECT menu item and press the key.
Select the project number to go to using the numeric keys, the and keys or the
Jog/Shuttle Wheel and press the key.
To Next Page
Loading...
