iZ Technology Corporation
RECORD VERIFY
This preference determines whether or not RADAR will operate in a RECORD VERIFY mode when
recording. Record Verify is a low-level data verification option. It is not recommended that this option be
enabled as it could slow down overall functionality. The RECORD VERIFY default preference is set to
Disabled.
To enable or disable RECORD VERIFY during recording:
Use the , the and keys and the key to go to the MAIN MENU /
PREFERENCES MENU / RECORD PREFS menu selection and press the key.
Use the and keys to select RECORD VERIFY and press the key.
At the RECORD VERIFY: dialogue, use the and keys to select either DISABLED or
ENABLED and press the key. The factory default setting is DISABLED.
MONITORING AND TRACK STATUS
During tracking and overdubbing there are two modes for audio that can be referenced, managed and
monitored: input (record/input mode); and the recorded signal (repro mode). RADAR uses the Track Arm
keys, the key and the key to create an easy to manage system for switching
between these source modes.
TRACK ARM KEYS
These keys are used extensively in RADAR operations as track selection keys. While recording and
overdubbing they are used to record enable and disable tracks 1-24 and switch them in and out of input
monitoring mode.
The KC-24 uses a key to record enable and disable tracks 13-24.
To monitor an input signal using input mode:
Press the desired Track Arm keys on the Session Controller or KC-24.
View the input level to the RADAR using the Meterbridge 24/48 or RADARView as a visual
reference.
To Next Page
Loading...
