www.izcorp.com • 1.800.776.1356
DISPLAY
______________________________________________
While most RADAR users connect an SVGA monitor to make use of the RADARView display, it is
important to note that a monitor is not required with the optional Session Controller. The Session
Controller makes RADAR
exceptionally portable and ideally suited for remote applications
Both RADARView and the Session Controller display the current position within a project. This
information can be viewed in several different ways:
FEET/FRAMES This is used for specific film applications.
BARS/BEATS
The RADAR
tempo setting is used to calculate and display positions
based on musical notation. This can be handy when working with a
locked MIDI sequencer.
SMPTE
SMPTE (Society of Motion Picture and Television Engineers) is the
most common format and is RADAR‘s default display. SMPTE is
displayed in Hours:Minutes:Seconds:Frames plus sub-frames
display.
INT/EXT SMPTE
While in chase, the Session Controller will display the project’s
current time above the master machines current timecode position.
The RADARView display shows only the master machine’s
timecode position in this mode.
RADAR
Sub-frames are not SMPTE bits. Each sub-frame is a 100
th
of a frame. Sub-
frames are only accessible if the SHOW SUB-FRAMES preference is selected in the
MAIN MENU / PREFS MENU / SHOW SUB-FRAMES dialogue.
To change the display mode of a project:
Use the , the and keys and the key to go to the MAIN MENU / PROJ ECT
MENU / DISPLAY MODE selection and press the key.
Use the and keys to select the format and press the key.
To Next Page
Loading...
