www.izcorp.com • 1.800.776.1356
SYNCHRONIZATION
When synchronizing a RADARLink configuration to an external source such as SMPTE timecode, only
the master RADAR is involved. The master in turn sends its clock data to each of the slave units providing
sample accurate synchronization information to the entire system. Because the sample clock is sent
through the RADARLink cabling, no extra cabling is required between the master and connected slave
units.
EDITING IN LINK MODE
When in LINK MODE, connected RADAR units act as a single multi-track recorder. There are, however,
some exceptions. Because the Session Controller only has 48 track-arming keys, performing edits using
more than 48 tracks requires entering solo mode.
To edit in LINK MODE:
Select the MARK IN and MARK OUT points.
Use the , the and keys and the key to go to the MAIN MENU / EDIT
MENU or use the direct access keys on the Session Controller or the KC-24 keyboard to select
the desired editing function.
Use the Track Arm keys to select the tracks to include in the edit. In RADARLink configurations
with more than 48 tracks, each additional RADAR unit must be soloed to select the tracks that will
be included in the edit.
It is not possible to move or paste audio from one RADAR to another.
To Next Page
Loading...
