www.izcorp.com • 1.800.776.1356
RADARLINK
__________________________________________
RADARLink allows multiple RADAR units to be linked together and controlled from a single Session
Controller. All slaved RADAR units are locked to the internal clock of the Master RADAR so that all
recordings made across multiple machines maintain a sample accurate relationship.
While in RADARLink mode, the following operations are available:
• All transport functions including PLAY, RECORD, STOP, FFWD, RWD and
JOG/SHUTTLE
• Cue functions including LOCATE and ENTER TIME
• Synchronization
• Editing
• System parameters and preferences
• Mount/Unmount of Record drives
– When selecting MOUNT or UNMOUNT on a RADARLink master, the slave unit
will also MOUNT or UNMOUNT.
• Shutdown/power up of master and slave
– When selecting SHUTDOWN RADAR from the MAIN MENU on the RADARLink
master, both the master and slave will be prepared for shutdown. When a
RADARLink master is restarted, it will wait 30 seconds (for the slave to be ready)
then automatically attempt to go back into RADARLink mode.
RADARLink hookup requires standard, fully populated pin to pin, 9-pin, male to female cables, which are
available at most computer stores.
Connect units together with the 9-pin cable running from the master unit’s RLINK OUT connector to the
RLINK IN connector on the slave RADAR. If more slave connections are required connect the RLINK
OUT on the first slave unit to the RLINK IN connector on the second slave and so on. The RLINK
connectors are located on the right side of the back panel.
The entire length of cabling between the RADAR units must be less than 10 meters (30
feet).
All RADAR units in the RADARLink system must all use the same RADAR software
version and RADAR recording engine (Adrenaline or Adrenaline Plus).
To Next Page
Loading...
