www.izcorp.com • 1.800.776.1356
If RADARLink has just been established, all slave units will cue to the current location of the master
machine. If RADARLink is re-established following a RLINK SOLO MODE operation all slaves will be
cued to the current position of the last soloed unit.
If there is an ID conflict re-enter RADARLink mode after changing the conflicting slave ID
number to enable any changes.
It is possible to remove just one machine from RADARLink but it requires that a remote be connected to
the unit being unlinked. Pressing the key on the connected remote will initiate the CANCEL
RADARLINK dialogue. Note that disabling RADARLink on a slave machine in this way only applies to
that specific unit and has no effect on the rest of the chain.
LINK MODE
In LINK MODE - the main mode of operation when using RADARLink - the master RADAR has control
over all other RADAR units in the configuration. LINK MODE commands are sent from the master unit to
all slave units for simultaneous execution.
When this mode is engaged the master unit forces all slave units to conform to its current settings and
system parameters including:
• Sample Rate
• TC Rate
• Crossfade Time
• Pre/Post Roll Time
• Auto-Input, Auto-Play, Auto-Punch, Cycle, Record Safe
• System Preferences, Time/Date
• Project Number
• Locate Points and Labels
• File Flattening
RLINK SOLO MODE
RLINK SOLO MODE allows the user to select any single RADAR unit in the RADARLink chain and
operate it independently from all of the others.
The following functions will only operate on slave machines when RLINK SOLO MODE is engaged:
• Disk functions (diagnostic operation, upgrade system, reclaim space etc.)
• Backups and Restores
• Importing and Exporting
• Digital I/O parameter adjustment
To Next Page
Loading...
