iZ Technology RADAR - Import; File Import

www.izcorp.com • 1.800.776.1356
OPERATIONS
RADAR 3.50
90
IMPORT
When importing, make sure that the DVD-R or CD-R being importing from has been
written as an ISO 9660 format on a Mac or PC.
RADAR has the capability of importing WAV and/or Broadcast W AV files into the clipboard or into a new
project from a variety of devices. These devices include D:ARCHIVE (RADAR internal IDE system drive),
N: NETWORK, DVD-R, CD-R, RED BOOK AUDIO CD, FAT32 formatted DVD-RAM and any Mac HFS
or FAT32 drives internally and/or externally connected to the RADAR SCSI bus.
If the project sample rate and bit resolution do NOT match the incoming file(s), there is an option to
convert the audio to the bit depth and sample rate of the current project based on the REFORMAT
QUALITY preference. If the project sample rate and bit resolution match the incoming file(s) and
reformatting won’t be required to reformat.
To set the REFORMAT QUALITY preference:
a. Use the , the and keys and the key to go to the MAIN MENU /
FILE MENU / FILE PREFS / REFORMAT QUALITY selection and press the key.
b. At the REFORMAT QUALITY: prompt, use the and keys to select Q1, Q2 or Q3
and then press the key.
Q3 represents the slowest speed but highest quality.
There are two ways to initiate a file import from the RADAR:
• Using the MAIN MENU / FILE MENU / IMPORT, which can be accessed using both the
Session Controller or the KC-24.
• Using the or keys on the Session Controller.
FILE IMPORT
To import audio into a new project:
Press the key on the Session Controller or use the , the and keys
and the key to go to the MAIN MENU / FILE MENU / IMPORT selection and press the
key.
At the IMPORT FROM: dialogue, use the and keys to select the device to import from
and press the key.