iZ Technology Corporation
DIGITAL TO ANALOGUE CONVERTERS
RADAR’s world class converters can be used as an output converter for a DAW system. RADAR can be
equipped with AES, TDIF, ADAT, MADI digital I/O.
For best quality use RADAR’s clock as the master clock.
To use RADAR as a Digital to Analogue converter for a DAW system, first set RADAR as the master
clock source:
Connect a clock cable from RADAR’s output into the DAW’s input.
Set the DAW to clock (sync) to external clock.
Now the DAW will be using RADAR’s internal clock for clocking.
To transfer digital audio:
Connect digital audio cables between RADAR’s inputs and the DAW’s digital outputs.
Set the DAW to output these digital outputs.
Press the
key on the Session Controller or the , the and keys and the
key to go to the MAIN MENU / I/O MENU / DIGITAL INPUTS press the key.
Use the and keys to select the digital format and press the key.
Press the Track Arm keys on the RADAR Session Controller.
Enable the DAW to play.
Route or monitor RADAR’s analogue outputs with a console.
RADAR always outputs all formats – it is not required to set the output.
It is not required to have a drive mounted in RADAR to pass audio.
Make sure both the DAW and RADAR are set to the same sample rate.
To Next Page
Loading...
