www.izcorp.com • 1.800.776.1356
Select YES at the RECLAIM SPACE? prompt and press the key.
Select the NO or YES option to keep or lose the UNDO LIST audio references and press the
key. If selecting YES, all undo possibilities for every project currently on the drive will be
lost. Proceed with CAUTION.
Select YES at the ARE YOU SURE? prompt and press the key.
MAKE DISK PORTABLE
This feature should be used when a Non-BWAV audio disk will be used on other RADAR units running
previous versions of software or when using a Non-BWAV RADAR disk in a RADARII. MAKE
PORTABLE can also be a request each time + (UNMNT) is pressed. This preference can be set
in the MAIN MENU / PREFERENCES MENU / UNMOUNT PORTABLE dialogue.
Mounting a BWAV audio drive in a RADAR II or in a RADAR 24/V running software pre
3.35 will destroy all the data on that drive.
In order to allow audio disks to be accessible to RADARII and RADAR24 units running
3.26 or older software, verify that NO projects exist above number 99. Projects numbered
100 or greater may be lost. Renumber all projects to a number less than 100 and/or
BACKUP before proceeding.
To make a disk portable:
Use the , the and keys and the key to go to the MAIN MENU / DISK
MENU / MAKE PORTABLE dialogue and press the key.
At the MAKE PORTABLE DISK? prompt, select YES and press the key.
If the audio disk contains one or more projects greater than 99, the following dialogue will be
displayed:
After this display, press the key and the following will be displayed:
Press the key to continue or to stop the process.
MAY LOSE AUDIO
IN 3.26 OR BELOW
PROJ>99:USE ONLY
IN 3.30 OR ABOVE
To Next Page
Loading...
