iZ Technology Corporation
DIALOGUES
____________________________________________
Upon arriving at the end of any given menu tree, the user will be presented with some sort of selection or
a set of fields for entering values. Values can be entered using any of RADAR’s data entry methods
including the numeric keys, arrow keys and the Jog/Shuttle Wheel.
DIRECT ACCESS KEYS
___________________________________
Both the Session Controller and the KC-24 have a wide range of keys that offer one-key access to a
particular function. Most of the direct access keys provide short cuts to menu items but some provide
functions that are not available via the menu.
DISK MANAGEMENT
_____________________________________
RADAR uses SCSI, SATA or PATA hard disks in removable drive carriers for audio recording. Hard disks
are a robust recording and storage medium, but proper care should be taken when handling, storing or
transporting them. As drives are mechanical devices that wear over time, scheduled replacement is
recommended for best reliability. Please take note of the following important points:
• Use only iZ drives and carriers which can be purchased directly from iZ or from one of our
authorized dealers.
• Newly purchased drives are initialized for native BWAV recording, but can be initialized for a
different format using the MAIN MENU / DISK MENU / INIT DISK menu dialogue before use.
Initializing a disk erases any existing data permanently. Use with caution.
• Properly initialized external SCSI backup drives connected via the 68-pin SCSI connector on the
back of the RADAR must be connected and powered up before booting the system.
• Any valid recording drive on the default SCSI ID will automatically be mounted upon boot up.
To Next Page
Loading...
