www.izcorp.com • 1.800.776.1356
AUTO INPUT
AUTO INPUT allows the RADAR to automatically switch between monitoring the input signal and the
recorded audio when playback begins and ends. This feature should be used when performing overdubs
and punches.
To enable auto input:
Press the
key on the Session Controller or KC-24.
While stopped, the RADAR will monitor the input signal on all tracks that are readied.
When playback begins, monitoring switches to reproduce mode and all tracks playback audio
from the disk.
Entering record mode begins recording on all armed tracks. RADAR switches to input mode for
monitoring the source signal that is being recorded.
TRACK SOLO
TRACK SOLO mutes the output of all tracks except the ones selected using the Track Arm keys. TRACK
SOLO can also be automatically engaged in tandem with the ZOOM SOLO (Session Controller only)
function, which is used to visually solo a track or group of tracks on the RADARView display. This
preference can be set in the MAIN MENU / PREFERENCES MENU / ZOOM SOLO AUDIO dialogue.
To use TRACK SOLO mode:
Press the
key on the Session Controller or KC-24.
Use the Track Arm keys to select the tracks to solo.
SAFE(CLEAR)
SAFE(CLEAR) puts all tracks into safe mode. In this state no recording can take place under any
circumstances. By pressing + (CLEAR) all tracks with record ready status can be cleared.
To use the (CLEAR) key:
Press the (CLEAR) key on the Session Controller or KC-24.
To clear record ready status on all tracks press + (CLEAR).
Pressing while recording prevents accidentally exiting record by ignoring all buttons
except (Play) and (Stop).
To Next Page
Loading...
