www.izcorp.com • 1.800.776.1356
If ENABLED is selected use the and keys to select STOP or CUE NEXT from the AT
LOCATE POINT prompt and press the key. If CUE NEXT is selected RADAR will jump to
the next locate point and stop.
When installing software onto 3.41 and below this preference is set to DISABLED.
If ENABLED is selected: At the AT LOCATE POINT prompt use the and keys to select
STOP or CUE NEXT.
• Selecting STOP will cause RADAR to stop during play when encountering the next locate
on the timeline.
• Selecting CUE NEXT will cause RADAR to skip to the next locate and stop when
encountering the next locate on the timeline.
• If PREROLL is enabled, it will add and preset offset to the locate.
• If AUTOPLAY is enabled, then RADAR will enter PLAY mode after locating. The status of
this setting will not affect the operation of other play commands with defined ending
points such as down arrow or cycle.
ASSIGN FT-SWITCH FUNCTION
Use the , the and keys and the key to go to the MAIN MENU /
PREFERENCES / ASSIGN FT-SWITCH dialogue and press the key.
At the ASSIGN FT-SWITCH: prompt use the and keys to select the FOOT SWITCH
INPUT, and then the key to select the function or macro the footswitch will perform.
ASSIGN MMC LOC FUNCTION
Use the , the and keys and the key to go to the MAIN MENU /
PREFERENCES / ASSIGN MMC LOC dialogue and press the key.
At the ASSIGN MMC LOC: prompt use the and keys to scroll though the list of MMC
LOCATE INFORMATION FIELD NAMES, 08, 09, 0A, 0B, 0C, 0D, 0E, and 0F and then
and scroll to select an item from the list of 8 MACRO BUTTONS, the GOTO PREV LOC or GOTO
NEXT LOC function, or the GOTO SYNC MRK function (default) to select the MMC LOCATE
ASSIGNMENT and press the key.
To Next Page
Loading...
