iZ Technology Corporation
When the key is engaged the system automatically switches
monitoring from INPUT to PLAYBACK when playback begins and returns it to
INPUT when playback stops.
Enter a time value and press to locate the current position to that time.
Use this key - located at the bottom right of the numeric keypad - in
conjunction with the numeric keys,
/ / keys and
to recall locate points.
QWERTY KEYS AND NUMERIC KEYPAD
The QWERTY keys are used to enter names and values into the system. Please note that keys in use as
transport or custom controls will not work like their counterparts on a conventional keyboard. Use the
and keys provided on the right hand side of the keyboard.
The Numeric keypad is used to enter values and to recall locate points in the project.
TRANSPORT CONTROLS
Standard transport controls are provided: (Rewind), (Fast Forward), , , and .
The key is at the top of the numeric pad. Press and use the and keys to scrub the audio.
If a mouse is attached to the rear of the RADAR, the mouse can be used as an alternative method for
scrubbing audio.
The key is next to the key at the top of the numeric pad. Press and use the mouse to
begin shuttling audio either forwards or in reverse.
LOCATE/TRANSPORT FUNCTION KEYS
This key grouping is located above the arrow keys and contains the following keys:
When used in conjunction with any RECALL LOCATE functions AUTO PLAY
initiates playback automatically once the specified timeline location has been
cued.
AUTO PUNCH uses the MARK IN and MARK OUT locate points to
automatically initiate and terminate recording. Please see OPERATIONS:
RECORDING: AUTO PUNCH for further information.
MARK IN defines the starting point of a track-region. See OPERATIONS:
EDITING: MARKING A TIME REGION for details.
MARK OUT defines the end point of a track-region. See OPERATIONS:
EDITING: MARKING A TIME REGION for further information.
To Next Page
Loading...
