iZ Technology Corporation
CHASE CUE TIME
This setting allows the CHASE CUE TIME to be adjusted. When chasing timecode, one factor in the
delay before RADAR begins chasing is the length of time spent waiting to guarantee that the disk has
cued to any arbitrary point in the project. If the cue time will always be shorter (for example, if only six
tracks are being played back, or playing back from a very fast hard disk), the time can be reduced. The
default chase cue time is 1.6 seconds.
To adjust the chase cue time:
Use the
, the and keys and the key to go to the MAIN MENU / SYNC
MENU / TC SETTINGS / CHASE CUE TIME
dialogue and press the key.
At the
CHASE CUE TIME: prompt use the
and keys to adjust the time from 0.2-2.0
seconds and press the
key to confirm the selection.
Be sure that the time is set long enough to allow the disk to cue to any point in the
projects. The cue time increases with number of tracks recorded and the amount of editing
in a project.
30 - 1
To Next Page
Loading...
