iZ Technology RADAR - Page 250

iZ Technology Corporation
MANUAL ADDENDUM
RADAR VERSION 3.
5
3
TRACK ARM RECALL AND ZOOM LEVEL RECALL
The TRACK ARM RECALL and ZOOM LEVEL RECALL features allow the track arm and zoom level
status of a project to be saved with the project file. New preferences have been added for
TRACK ARM
RECALL
and ZOOM LEVEL RECALL. When enabled, switching to a project will restore the arm-readied
tracks and/or the vertical and horizontal zoom levels to the state they were when the project was last
accessed. These preferences are found in the
PREFERENCES MENU.
To enable
TRACK ARM RECALL:
Use the , the and keys and the key to go to the MAIN MENU /
PREFERENCES MENU / TRACK ARM RECALL
selection and press the key.
At the TRACK ARM RECALL dialogue use the and keys to select ENABLED and press
the
key.
To enable
ZOOM LEVEL RECALL:
Use the , the and keys and the key to go to the MAIN MENU /
PREFERENCES MENU / ZOOMLEVEL RECALL
selection and press the key.
At the ZOOMLEVEL RECALL dialogue use the and keys to select ENABLED and press
the
key.
70 - 1