iZ Technology Corporation
To export a template to be used on another RADAR:
Go to the MAIN MENU / PROJECT MENU / TEMPLATE MENU and press the key.
Use the and keys, select EXPORT TEMPLATE and press the key.
At the EXPORT TEMPLATE prompt, choose ALL TEMPLATES or SELECT TEMPLATES and
press the key. If selecting ALL TEMPLATES skip to step 5.
If choosing SELECT TEMPLATES use the and keys to select templates and the to
mark them to be exported. Once the desired templates are selected press the key.
At the EXPORT TO: prompt, use the and keys to select the device to save to, and press
the key. This list will include D:ARCHIVE (RADAR internal system drive partition),
N:NETWORK, A:FLOPPY, B: (DVD-RAM, DVD-R, BD-RE or CD-R), REV DISK, E:USB DRIVE
and any FAT32 or HFS Standard formatted SCSI drives connected to the RADAR.
To import a template from another RADAR:
Go to the MAIN MENU / PROJECT MENU / TEMPLATE MENU and press the key.
Use the and keys, select IMPORT TEMPLATE and press the key.
At the IMPORT FROM: prompt, use the and keys to select the device to import from, and
press the key. This list will include D:ARCHIVE (RADAR internal system drive partition),
N:NETWORK, A:FLOPPY, B: (DVD-RAM, DVD-R, BD-RE or CD-R), REV DISK, E:USB DRIVE
and any FAT32 or HFS Standard formatted SCSI drives connected to the RADAR. Once the
template folder is selected press the key.
At the IMPORT TEMPLATE prompt, choose ALL TEMPLATES or SELECT TEMPLATES and
press the key. If selecting ALL TEMPLATES skip to step 6.
If choosing SELECT TEMPLATES use the and keys to select templates and the to
mark them to be exported. Once the desired templates are selected press the key.
At the XX FLS/ XXMB PROCEED? select YES and press the key.
After you have finished using a USB drive, make sure you unmount it before unplugging it
from RADAR. You can access the MOUNT/UNMOUNT dialog via the DISK MENU or by
pressing + UNMNT on the Session Controller.
To delete a template from RADAR:
Go to the MAIN MENU / PROJECT MENU / TEMPLATE MENU and press the key.
Use the and keys, select DELETE TEMPLATE and press the key.
Use the and keys to select templates and the to mark them to be exported. Once the
desired templates are selected press the key.
At the XX FLS/ XXMB PROCEED? select YES to confirm deletion and press the key.
To Next Page
Loading...
