2MN/2N1
1-3-120
U464 Setting: [Leaving Time]
1. Change the setting value using the numeric keys.
2. Press the OK key. The value is set.
Setting: [Driving Time]
1. Change the setting value using the numeric keys.
2. Press the OK key. The value is set.
Setting: [Timing]
1. Change the setting value using the numeric keys.
2. Press the OK key. The value is set.
Setting: [Target Value]
1. Select the item.
2. Change the setting value using the numeric keys.
3. Press the OK key. The value is set.
Item No. Description
Display Description Setting range
Initial
setting
Time(min) Setting the standard time of sleep mode 0 to 480 (min) 480
Display Description Setting range
Initial
setting
Time(sec) Setting the drive standard time 300 to 3000 (s) 300
Display Description Setting range
Initial
setting
Time(sec) Setting the drive standard time of con-
tinuous print
0 to 3600 (s) 3600
Display Description
Setting
range
Initial setting
45ppm 55ppm
Thick-
ness(C)
Toner thick layer calibration
(cyan)
0 to 1000 890 890
Thick-
ness(M)
Toner thick layer calibration
(magenta)
0 to 1000 910 910
Thick-
ness(Y)
Toner thick layer calibration
(yellow)
0 to 1000 910 910
Thick-
ness(K)
Toner thick layer calibration
(black)
0 to 1000 760 790
Gamma(C) Light amount calibration
(cyan)
0 to 500 320 320
Gamma(M) Light amount calibration
(magenta)
0 to 500 320 320
Gamma(Y) Light amount calibration
(yellow)
0 to 500 300 300
Gamma(K) Light amount calibration
(black)
0 to 500 350 350