Lenze 8400 - Page 1032

15 Parameter reference
15.2 Parameter list
1032
Lenze · 8400 HighLine · Reference manual · DMS 12.0 EN · 06/2017 · TD23
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00980
C00981
C00982
Parameter | Name:
C00980 | Power display
Data type: INTEGER_32
Index: 23595
d
= 5C2B
h
From version 10.00.00
Display parameter for an energy analysis in the prevailing application. From this, decisions can be deduced whether
a measure for energy optimisation is economic.
Display range (min. value | unit | max. value)
-180.000 kW 180.000
Subcodes Info
C00980/1 Active output power
C00980/2 Apparent output power
C00980/3 Rated device power
• From version 17.00.00 onwards
C00980/4 Input power
• From version 17.00.00 onwards
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1000
Parameter | Name:
C00981 | Energy display
Data type: INTEGER_32
Index: 23594
d
= 5C2A
h
From version 10.00.00
Display parameter for an energy analysis in the prevailing application. From this, decisions can be deduced whether
a measure for energy optimisation is economic.
• The values are saved to the device by switching off the mains and cannot be reset.
Display range (min. value | unit | max. value)
0.00 kWh 21474836.47
Subcodes Info
C00981/1 Output energy in motor mode
C00981/2 Output energy in generator mode
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100
Parameter | Name:
C00982 | VFC-ECO: Voltage reduction ramp
Data type: UNSIGNED_8
Index: 23593
d
= 5C29
h
From version 10.00.00
Voltage ramp for cancelling V-Sub with energy-saving V/f characteristic control (VFCplusEco
)
Setting range (min. value | unit | max. value) Lenze setting
0.0 s 5.0 power-related (see table
)
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 10