Lenze 8400 - Page 1074

15 Parameter reference
15.2 Parameter list
1074
Lenze · 8400 HighLine · Reference manual · DMS 12.0 EN · 06/2017 · TD23
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C01225
C01226
C01227
Parameter | Name:
C01225 | MCK: Ref. accelerations
Data type: INTEGER_32
Index: 23350
d
= 5B36
h
Accelerations for reference search/homing
Homing
Setting range (min. value | unit | max. value)
0.0000 unit/s2 214748.3647
Subcodes Lenze setting Info
C01225/1 720.0000 unit/s2 MCK: Ref. initial acceleration
• Starting acceleration for the starting speed ramps.
C01225/2 720.0000 unit/s2 MCK: Ref. search acceleration
• Search acceleration for the search speed ramps.
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 10000
Parameter | Name:
C01226 | MCK: Ref. S-ramp time
Data type: UNSIGNED_16
Index: 23349
d
= 5B35
h
S-ramp time for reference search/homing
•Setting "0 s" ≡ no rounding
Homing
Setting range (min. value | unit | max. value)
0.000 s 10.000
Subcodes Lenze setting Info
C01226/1 0.000 s MCK: Ref. S-ramp time
• S-ramp time for the starting and search speed ramps.
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1000
Parameter | Name:
C01227 | MCK: Ref. positions
Data type: INTEGER_32
Index: 23348
d
= 5B34
h
Positions for determining the zero position of the reference measuring system
Homing
Setting range (min. value | unit | max. value)
-214748.3647 unit 214748.3647
Subcodes Lenze setting Info
C01227/1 0.0000 unit MCK: Ref. offset reference degree
• Relative traverse path by which the drive traverses
correctly signed with search speed after detection of
the sensor reference signal.
C01227/2 0.0000 unit MCK: Ref. home position
• Position with which setpoint and actual position are
loaded after completion of homing.
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 10000