Lenze 8400 - Page 1077

Lenze · 8400 HighLine · Reference manual · DMS 12.0 EN · 06/2017 · TD23 1077
15 Parameter reference
15.2 Parameter list
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C01233
C01234
C01235
Parameter | Name:
C01233 | MCK: Manual jog S-ramp time
Data type: UNSIGNED_16
Index: 23342
d
= 5B2E
h
S-ramp time for manual jog
•Setting "0 s" ≡ no rounding
Manual jog
Setting range (min. value | unit | max. value)
0.000 s 10.000
Subcodes Lenze setting Info
C01233/1 0.000 s Manual jog: S-ramp time
• S-ramp time for the manual speed ramps.
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1000
Parameter | Name:
C01234 | MCK: Manual jog breakpoints
Data type: INTEGER_32
Index: 23341
d
= 5B2D
h
Breakpoint positions for manual jog
• The drive stops at the parameterised positions if these are located in the manual jog direction and the
approaching of the breakpoints is switched on in C01230
via bit 0.
Manual jog
Setting range (min. value | unit | max. value)
-214748.3647 unit 214748.3647
Subcodes Lenze setting Info
C01234/1 0.0000 unit Manual jog: Breakpoint 1
C01234/2 0.0000 unit Manual jog: Breakpoint 2
C01234/3 0.0000 unit Manual jog: Breakpoint 3
C01234/4 0.0000 unit Manual jog: Breakpoint 4
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 10000
Parameter | Name:
C01235 | MCK: Manual jog waiting times
Data type: UNSIGNED_16
Index: 23340
d
= 5B2C
h
Waiting times for manual jog
Manual jog
Setting range (min. value | unit | max. value)
0.000 s 65.000
Subcodes Lenze setting Info
C01235/1 5.000 s Manual jog: Waiting time 2nd speed
• Time after which the first manual speed (C01231/1
) is
accelerated to the second manual speed (C01231/2
).
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1000