Lenze 8400 - Page 1102

15 Parameter reference
15.2 Parameter list
1102
Lenze · 8400 HighLine · Reference manual · DMS 12.0 EN · 06/2017 · TD23
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C01770
C01771
C01772
C01773
C01774
C01775
C01902
Parameter | Name:
C01770 | Filter time - earth-fault detect. is running
Data type: UNSIGNED_8
Index: 22805
d
= 5915
h
From version 05.00.00
Setting range (min. value | unit | max. value) Lenze setting
0 ms 250 2ms
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C01771 | BU-Osc: Cycle time selection
Data type: UNSIGNED_8
Index: 22804
d
= 5914
h
This code is for device-internal use only and must not be written to by the user!
Parameter | Name:
C01772 | BU-Osc: Trigger channel selection
Data type: UNSIGNED_8
Index: 22803
d
= 5913
h
This code is for device-internal use only and must not be written to by the user!
Parameter | Name:
C01773 | BU-Osc: Trigger command
Data type: UNSIGNED_8
Index: 22802
d
= 5912
h
This code is for device-internal use only and must not be written to by the user!
Parameter | Name:
C01774 | BU-Osc: Trigger mode
Data type: UNSIGNED_8
Index: 22801
d
= 5911
h
This code is for device-internal use only and must not be written to by the user!
Parameter | Name:
C01775 | BU-Osc: Trigger
Data type: INTEGER_16
Index: 22800
d
= 5910
h
This code is for device-internal use only and must not be written to by the user!
Parameter | Name:
C01902 | Diagnostics X6: Max. baud rate
Data type: UNSIGNED_16
Index: 22673
d
= 5891
h
Maximally permissible baud rate in the standard device after determination of the baud rate at the diagnostic
interface X6