Lenze 8400 - Page 677

Lenze · 8400 HighLine · Reference manual · DMS 12.0 EN · 06/2017 · TD23 677
9 Diagnostics & error management
9.9 Error messages of the operating system
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
dH09: EEPROM power section [xx.0400.00009]
dH10: Fan failure [xx.0400.00016]
dH68: Adjustment data error CU [xx.0400.00104]
dH69: Adjustment data error BU [xx.0400.00105]
dH70: ControlUnit is unequal to BaseUnit [xx.0400.00106]
User error 1 [xx.0980.00000 ... xx.0980.65535]
Response (Lenze setting printed in bold)
 0: No Reaction  1: Fault  2: Trouble  3: TroubleQuickStop  4: WarningLocked  5: Warning  6: Information
Cause Remedy
Device error Please contact Lenze.
Response (Lenze setting printed in bold) Setting: C00566 ( Adjustable response)
 0: No Reaction  1: Fault  2: Trouble  3: TroubleQuickStop  4: WarningLocked  5: Warning  6: Information
Cause Remedy
The device fan has failed.
Possible causes:
• The short-circuit check of the fan connection has
tripped.
• The speed monitoring of the fan has tripped.
• Check the fan for short-circuit.
•Clean the fan.
Response (Lenze setting printed in bold)
 0: No Reaction  1: Fault  2: Trouble  3: TroubleQuickStop  4: WarningLocked  5: Warning  6: Information
Cause Remedy
Device error Please contact Lenze.
Response (Lenze setting printed in bold)
 0: No Reaction  1: Fault  2: Trouble  3: TroubleQuickStop  4: WarningLocked  5: Warning  6: Information
Cause Remedy
Device error Please contact Lenze.
Response (Lenze setting printed in bold)
 0: No Reaction  1: Fault  2: Trouble  3: TroubleQuickStop  4: WarningLocked  5: Warning  6: Information
Cause Remedy
Device error Please contact Lenze.
Response (Lenze setting printed in bold) Setting: C00581/1 ( Adjustable response)
 0: No Reaction  1: Fault  2: Trouble  3: TroubleQuickStop  4: WarningLocked  5: Warning  6: Information
Cause Remedy
User error 1 has been tripped via the bSetError1 input of
the LS_SetError_1
system block.
User-defined.