Lenze 8400 - Page 812

15 Parameter reference
15.2 Parameter list
812
Lenze · 8400 HighLine · Reference manual · DMS 12.0 EN · 06/2017 · TD23
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00003
C00005
Parameter | Name:
C00003 | Status of last device command
Data type: UNSIGNED_8
Index: 24572
d
= 5FFC
h
Status of the device command executed last (C00002).
Note:
Before switching off the supply voltage after carrying out a device command, check whether the device command
has been carried out successfully via the status display!
Drive control (DCTRL)
: Device commands
Selection list (read only) Info
0 Successful Device command has been executed successfully.
1 Command unknown Device command implausible or unknown to the system.
2 Password protection Unauthorised access for requested device command.
Password protection
3 Time-out Device command could not be processed in the defined
time (timeout).
4 System fault
5 Command server assigned
6 Controller inhibit required
7 unexpected controller inhibit
10 Memory module binding error Device personalisation
11 Password too short Password protection
12 Wrong password
13 Password already set
14 Password not assigned
15 Incorrect checksum
30 Incorrect pole position identification
31 Pole position identification started
without encoder
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00005 | Application
Data type: UNSIGNED_16
Index: 24570
d
= 5FFA
h
Selection of the technology application
Selection list (Lenze setting printed in bold) Info
0 Wiring has changed This display appears if the FB interconnection has been
changed in the application level using the FB Editor.