Lenze 8400 - Page 964

15 Parameter reference
15.2 Parameter list
964
Lenze · 8400 HighLine · Reference manual · DMS 12.0 EN · 06/2017 · TD23
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00728
C00729
C00730
C00731
C00727/3 0 1 ≡ request change of direction of rotation
C00727/4 0 1 ≡ request fixed speed setpoint 1
C00727/5 0 1 ≡ request fixed speed setpoint 2
C00727/6 0 1 ≡ motor potentiometer: request activation
C00727/7 0 1 ≡ motor potentiometer: request pos. acceleration
C00727/8 0 1 ≡ motor potentiometer: request neg. acceleration
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00727 | LS_Keypad digital values
Data type: UNSIGNED_8
Index: 23848
d
= 5D28
h
Parameter | Name:
C00728 | Keypad analog values
Data type: INTEGER_16
Index: 23847
d
= 5D27
h
Selection of different setpoints when operating via keypad
Setting range (min. value | unit | max. value)
-199.99 % 199.99
Subcodes Lenze setting Info
C00728/1 100.00 % Torque limit in motor mode
C00728/2 100.00 % Torque limit in generator mode
C00728/3 0.00 % Setpoint speed
• 100 % ≡ C00011
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100
Parameter | Name:
C00729 | Remote: Setpoint selection
Data type: INTEGER_16
Index: 23846
d
= 5D26
h
Setting range (min. value | unit | max. value)
-199.99 199.99
Subcodes Lenze setting Info
C00729/1 0.00 Remote: Setpoint keypad
C00729/2 0.00 Remote: Setpoint PC
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100
Parameter | Name:
C00730 | Oscilloscope scanning interval
Data type: UNSIGNED_32
Index: 23845
d
= 5D25
h
This code is for device-internal use only and must not be written to by the user!
Parameter | Name:
C00731 | Oscilloscope recording length
Data type: UNSIGNED_32
Index: 23844
d
= 5D24
h
This code is for device-internal use only and must not be written to by the user!