Unformatted flash detected [53]
Try one or more of the following:
• From the printer control, select Continue to stop the defragmentation and continue printing. For non‑touch‑screen
printer models, press
to confirm.
• Format the flash memory.
Note: If the error message remains, then the flash memory may be defective and need to be replaced.
Unsupported disk
1 Remove the unsupported disk, and then install a supported one.
2 Select Continue to clear the message and continue printing. For non‑touch screen printer models, press to
confirm.
Unsupported option in slot [x] [55]
1 Turn off the printer.
2 Unplug the power cord from the wall outlet.
3 Remove the unsupported option card from the printer controller board, and then replace it with a supported card.
4 Connect the power cord to a properly grounded electrical outlet.
5 Turn the printer back on.
USB port [x] disabled [56]
Try one or more of the following:
• Select Continue to clear the message. For non-touch-screen printer models, press to confirm.
The printer discards any data received through the specified serial port.
• Select Reset active bin to reset the active bin for a linked set of bins.
• Make sure the USB Buffer menu is enabled.
User attendance messages
User attendance messages (0‑99.99)
Error
code
Description Action
10.xx Too many vinyl labels printed successively. Reduce the vinyl labels printed. Print less than
50 vinyl labels in a row, or print at least one
vinyl label per six plain paper pages.
30.xx Toner cartridge missing Make sure all cartridges are installed properly.
4063
Diagnostic information
230
To Next Page
Loading...
Need help?
General
