Available options:
• Auto
• Full—Forces the USB port to run at full speed and also disables its high‑speed capabilities.
Automatically Display Error Screens
If On, the panel automatically displays any existing printer-related message after the printer remains inactive on the
home screen for a length of time equal to the Screen Timeout setting in the Timeouts section of the General Settings
Menu. Any message that appears on the display gives the option of returning to the home screen without clearing it.
From the home screen, any other workflow or feature can be initiated as usual. When the printer returns to the home
screen, any existing message will again appear after the printer remains inactive for a length of time equal to the Screen
Timeout setting.
To change this setting:
1 From the Configuration Menu, navigate to Automatically Display Error Screens.
2 Select from the available options:
• On (default)
• Off
3 Depending on the printer model, press OK or touch to save the setting, or press X to return to the Configuration
Menu without saving any changes.
USB PnP
In some cases, the USB port at the back of the printer may be incompatible with the chipset in a user’s PC. This setting
lets the user change the USB driver mode to improve its compatibility with these PCs.
Available options:
• 1
• 2
Entering invalid engine mode
This mode is used if the machine has invalid code and needs the correct code loaded. After entering this mode, the
firmware code can be updated.
1 Turn off the printer.
2 Press and hold the 3, 4, and 6 buttons simultaneously.
3 Turn on the printer.
4 Release the buttons after 10 seconds.
4063
Service menus
351
To Next Page
Loading...
Need help?
General
