Source Printing Printable side Paper orientation
Trays One‑sided Facedown Load the sheet with the
top edge toward the front
of the tray.
Trays Two‑sided Faceup Load the sheet with the
bottom edge entering the
printer first.
Multipurpose feeder One‑sided Faceup Load the sheet with the
top edge entering the
printer first.
Multipurpose feeder Two‑sided Facedown Load the sheet with the
bottom edge entering the
printer first.
Note: Check with the manufacturer or vendor to determine whether the preprinted letterhead is acceptable for laser
printers.
Tips on using transparencies
• From the printer control panel, set the paper size, type, texture, and weight in the Paper menu to match the
transparencies loaded in the tray.
• Print a test page on the transparencies being considered for use before buying large quantities.
• Use transparencies designed specifically for laser printers.
• Avoid getting fingerprints on the transparencies to prevent print quality problems.
• Before loading transparencies, flex and fan the sheets to prevent them from sticking together.
• When printing on large volumes of transparencies, make sure to print by batches of only up to 20 with an interval
of at least three minutes between batches, to prevent the transparencies from sticking together in the bin. You can
also remove transparencies from the bin by batches of 20.
Supported paper sizes, types, and weights
The following tables provide information on standard and optional paper sources and the types of paper they support.
Note: For an unlisted paper size, select the closest larger listed size.
Paper types and weights supported by the printer
The printer engine supports 60–176‑g/m
2
(16–47‑lb) paper weights.
Paper type 250‑ or 550‑sheet
trays
2100‑sheet tray Multipurpose feeder Duplex
Paper
Card stock X
Paper labels X X
Vinyl Labels
X X
4063
General information
47