Factory Defaults
Warning—Potential Damage: This operation cannot be undone.
This setting enables a user to restore all of the printer settings to either the network settings (on network models only)
or to the base printer settings.
To restore Factory Default settings:
1 From the Configuration menu, navigate to Factory Defaults.
2 Select from the available options:
• Restore Base—restores all non‑critical base printer NVRAM settings.
• Restore STD Net—restores all network NVRAM settings.
• Restore LES (available on touchscreen model only)—restores the factory default values for all framework,
standard applications and eSF configuration by removing all non‑standard applications; and clears the SE logs.
After this setting is changed, the device automatically performs a POR, and restores the appropriate settings to their
factory default values.
Energy Conserve
This setting controls which values appear on the Power Saver menu.
To change the setting:
1 From the Configuration menu, navigate to Energy Conserve.
2 Select On or Off.
If On (default), then the Sleep Mode cannot be turned off. If Off, then Disabled appears on the Sleep Mode
menu, and it can be turned off.
Paper Prompts
This controls which tray a change prompt is directed to when paper is sensed to be the wrong size.
Note: The value of “Action for Prompts” on page 346 may override the value of this setting.
To change this setting:
1 From the Configuration menu, navigate to Paper Prompts.
2 Select from the available options:
• Auto (default)
• Multi‑purpose Feeder
• Manual Paper
3 Depending on the printer model, press OK or touch to save the setting, or press X to return to the Configuration
menu without saving any changes.
When it is set to Auto, the emulator selected to print the job determines which of the installed input sources will receive
the change prompt. When set to a value other than Auto, the selected source always receives this type of prompt.
4063
Service menus
345
To Next Page
Loading...
Need help?
General
