Chapter 8 Program
8-5
(e) Jog Operation Command for each axis
Jog Operation works by setting or clearing directly its considered bit from U device not by a command. In this example
above, look at the axis 1, once Jog Operation conditions are satisfied, clockwise jog bit becomes ”On,’ count clockwise
jog bit becomes “Off’,” and jog speed bit becomes “On.” Everything together Jog Operation works clock wisely with high
speed. Reference for detail information about Bit of U device is from “Chapter 5.2.1.”
The value of U device renewed from Scan End of sequence program.
To Next Page
Loading...
