Minebea Intec X3 Process Indicator PR 5410 - Page 127

— 061 PIn Access code, for Standard application only
— 062 ALIbI Alibi, nonE, GroSS, nEt, Gr.nE.tA., Gr.nE. or
Gr.tA
— 063 SEqnr Next free sequence number
— 064 tArKEY Tare key, function, disable
— 065 ZErKEY Zeroset key, function, disable
— 066 nbtKEY N.B.T key, disable
— 067 PrtKEY Print key, disable
— 068 tStKEY Test key, disable
— PP Print parameters
— 073 PrtMod LAYout (direct)/nICELb (Nice Label)
— 074 LAYou1 Select element 1
— 075 LAYou2 Select element 2
— 076 LAYou3 Select element 3
— 077 LAYou4 Select element 4
— 078 LAYou5 Select element 5
— 079 LAYou6 Select element 6
— nP Print parameters
— 080 dHCP DHCP
— 081 IP.Addr IP address
— 082 SubnEt Subnet
— 083 Gt.Addr Gateway
— 084 CLIEnt VNC client
— 085 Et.Addr Hardware address (MAC ID)
This address is also located on the label on the
side of the device; see Chapter 7.9.
— dt Date and time
— 086 YEAr YYYY, dAtE: MM-TT, tIME: HH.MM
— VS Program versions
— 087 FIrM Firmware
— 088 bIoS Bios
— 089 boArd Board number
— FP Fieldbus parameters
— 090 Prot Protocol (e.g., [Pro.nET] for ProNet I/O)
— 091 PdPAdr PDP [Address]
— 092 dVnbdr DeviceNet [Baudrate]
— 093 dVnAdr DeviceNet [Address]
— 094 CCLbdr CC-link [Baudrate]
— 095 CCLAdr CC-link [Address]
— 097 IPAddr ProNet/EtherNet-IP [IP address]
— 098 SubMSK ProNet/EtherNet-IP [Subnet Mask]
— AL Alibi Memory
— 100 SEq Sequence number of alibi entry: Content
display/printout
— 101 ErASE Delete alibi memory content yes/no
— SI Serial interfaces
— 110 Print Printer
— Port See Chapter 7.17.1.
— 111 rEMdSP Remote display
— Port See Chapter 7.17.1.
7 Commissioning X3 Process Indicator PR 5410
EN-125 Minebea Intec