Minebea Intec X3 Process Indicator PR 5410 - Page 214

7.17.1.4 SMA protocol
Note:
The PR 5510/04 interface card must be installed in the device (see Chapter 4.6).
A selection window opens.
7. Select the desired parity and conrm.
8. Select [Slave ID] and conrm.
9. Enter and conrm the slave address (in this case: 65).
10. Press 2× to exit the menu and save.
1. Select [SMA] and conrm.
A selection window opens.
2. Select the desired interface and conrm.
The selected interface is displayed.
3. Press the [Param] softkey to set the parameters.
The following window opens:
X3 Process Indicator PR 5410 7 Commissioning
Minebea Intec EN-212