No. 99MBG518A
D-6
PART D : 2 Method to Test One Point
2.1
Test Method Settings
Set the test method.
1
Touch the [System] tab of the "condition setup" tab block.
» The System settings screen is dis-
played.
2
Set the test method.
1 Touch the [Test Method] button on the
"basic operation" block.
» The Test Method settings screen is
displayed.
2 Touch the [ASTM D785-B] button of
[Plastic].
For details about the test method, see
"4 Hardness Test Methods" (page
A-9) in "PART A Overview".
To Next Page
Loading...
