Mitutoyo HR-530 Series - Test Flow; Method to Test One Point

No. 99MBG518A
D-1
PART D : 1 Test Flow
1
Test Flow
1.1
Method to Test One Point
Thissectionexplainstheoperationowtotestonepoint.
Preparation
Test method settings
"2.1 Test Method Settings" (page
D-6)
Display conditions settings
"2.2 Display Conditions Settings"
(page D-7)
Indenter mounting
"2.3 Mounting the Indenter" (page
D-8)
Test time settings
"2.4 Test Time Settings" (page
D-8)
■When setting a correction value
Correction value settings
"2.5 Correction Value Settings"
(page D-9)
■When setting a GO/NG judgment
GO/NG judgment settings
"2.6 GO/NG Judgment Settings"
(page D-9)
Test for the specimen for obtaining
the correction value
"2.7 Test for the Specimen for Ob-
taining the Correction Value" (page
D-10)
Correction value setup
"2.8 Correction Value Setup" (page
D-14)