Mitutoyo HR-530 Series - Error Message List

No. 99MBG518A
I-5
PART I : 3 Error Message List
3
Error Message List
Ifthesameerrormessageappearsrepeatedly,contactyourdealerorthenearestMitutoyosaleso󰀩ce.
Display Status What to do
SRAM battery level
is low.
The voltage of the display
unit built-in battery dropped.
Back up necessary data to USB memory, and con-
tactyourdealerorthenearestMitutoyosaleso󰀩ce.
Timer error
An error occurred in the
CPU.
Contact your dealer or the nearest Mitutoyo sales
o󰀩ce.
Exter.output
Not connected
The external output device is
not connected.
Connect the external output device.
USB memory
Failure in writing
Data could not be saved
properly.
After checking the write-protect switch of the USB
memory and the available space on the USB memo-
ry, retry saving the data.
C-axis
Error : Linear Scale
An error occurred in the test-
ing machine built-in scale.
Turnthepowero󰀨,waitatleast10secondsafter
lowering the specimen stage, and turn the power on
again.
If the problem persists, contact your dealer or the
nearestMitutoyosaleso󰀩ce.
F-axis
Error : Linear Scale
Timeout Error
Loading arm did not move
to the target position after
a certain period of time had
passed, due to motor mal-
function, etc.
Turnthepowero󰀨,waitatleast10secondsafter
lowering the specimen stage, and turn the power on
again.
If the problem persists, contact your dealer or the
nearestMitutoyosaleso󰀩ce.
Force Limit Sensor
Error
The spring limit sensor was
activated due to malfunc-
tion of the sensor or testing
machine.
Turnthepowero󰀨,waitatleast10secondsafter
lowering the specimen stage, and turn the power on
again.
If the problem persists, contact your dealer or the
nearestMitutoyosaleso󰀩ce.
↑ZLimiterror
The limit sensor was activat-
ed due to malfunction of the
sensor or testing machine.
Turnthepowero󰀨,waitatleast10secondsafter
lowering the specimen stage, and turn the power on
again.
If the problem persists, contact your dealer or the
nearestMitutoyosaleso󰀩ce.
↓ZLimiterror
The origin setting
operation will be
started.
It was necessary to move the
loading arm to the standby
position before starting the
test.
Touch the [OK] button in the message. The loading
arm will automatically move to the standby position.
Failure in
measurement
1) Testing could not be exe-
cuted properly.
1) To redo the test, execute the test again. If the
problem persists, contact your dealer or the near-
estMitutoyosaleso󰀩ce.
2) The up/down handle was
operated during testing.
2) Do not operate the up/down handle during testing.
3) The specimen stage was
signicantlyloweredbe-
fore starting continuous
testing (2nd test or after).
3) Do not operate the up/down handle before starting
continuous testing (2nd test or after).
Approach load
error
1) The up/down handle was
operated too quickly be-
fore starting a test.
1) Operate the up/down handle slowly before starting
a test.
2) The up/down handle was
operated during testing.
2) Do not operate the up/down handle during testing.
3) The specimen stage was
not lowered enough.
3) When [Please lower the table] is displayed, the
specimenstagemustbesu󰀩cientlylowered.