Mitutoyo HR-530 Series - Method to Set a Group and Test Multiple Points; Test Method Settings; Display Conditions Settings; Indenter Settings

No. 99MBG518A
F-17
PART F : 3 Method to Set a Group and Test Multiple Points
3
Method to Set a Group and Test
Multiple Points
This chapter explains an example of the case of executing a Brinell hardness test on multiple
points set as a group. By setting a group, the average value of multiple test results can be
output as one data value. When calculating the average value, it is possible to exclude the
maximumandminimumvalues.Intheactualtest,setthetestforcespeciedinthetechnical
drawing, etc.
Setting item Setting value (example)
Test Method HB
Scale HBW
Number group 5
3.1
Test Method Settings
Set the test method.
For details about setting methods, see
"2.1 Test Method Settings" (page F-6).
3.2
Display Conditions Settings
Set each item related to the display.
For details about setting methods, see
"2.2 Display Conditions Settings" (page F-7).
3.3
Indenter Settings
Set the indenter.
For details about setting methods, see
"2.3 Indenter Settings" (page F-8).