Mitutoyo HR-530 Series - Connecting the Fine-Adjustment Table for Jominy Testing and the Foot Switch

No. 99MBG518A
B-11
PART B : 4 Connection of Various Cables
4.3
Connecting the Fine-Adjustment Table for Jominy
Testing and the Foot Switch
CAUTION
• A Mitutoyo service engineer will connect each connector and perform the wiring during delivery and instal-
lation. In the event a connector becomes disconnected, the connector needs to be connected as shown in
the diagrams. If you have any questions or concerns about the connection of each connector or the wiring,
contactthenearestMitutoyosaleso󰀩ce.
• Disconnect the power cable from the power input connector of the testing machine when connecting each
connectorandperformingwiring.Conrmtheuser'smanualforeachdeviceandperformtheprocedures
aftershuttingo󰀨thepowersupply.Checkwhetherthewiringbetweenconnectorsiscorrect,allthewires
have been connected, and whether there are any poor connections when making connections to connect the
connectors.
①
②
No. Name Function
①
Connectorforthene-ad-
justment table for Jominy
testing
Use the connecting cable for the specimen stage to connect the
ne-adjustmenttableforJominytesting.
②
Foot switch connector Use the connecting cable for the foot switch to connect the foot
switch.